General Category > LisaList2
RGBTOHDMI understands the Lisa video signal
ried:
stepleton's Lisa profile works on all of my Lisas, including a 2/10 (without the screen mod). This is the RGBTOHDMI that I use: https://www.ebay.com/itm/186793326425
AlexTheCat123:
If you're not already doing it this way, maybe try connecting straight to your Lisa's VSYNC, HSYNC, and VID signals instead of hooking the RGBtoHDMI to the Lisa's composite output. That's how I do it and it's incredibly reliable, not to mention sharp.
bmwcyclist:
--- Quote from: AlexTheCat123 on March 26, 2025, 11:53:50 am ---If you're not already doing it this way, maybe try connecting straight to your Lisa's VSYNC, HSYNC, and VID signals instead of hooking the RGBtoHDMI to the Lisa's composite output. That's how I do it and it's incredibly reliable, not to mention sharp.
--- End quote ---
I need to be able to use this for public presentations where the Lisa demonstrated.
Connecting to the signals requires running cables to the video card yes?
bmwcyclist:
I’ve made it to her. I have a stable screen, but there are two copies of it!
Don’t know much about video signals so I’m a bit lost. I’ve played with the Settings, but so far no luck.
sigma7:
--- Quote from: bmwcyclist on April 02, 2025, 08:17:58 pm ---
--- Quote from: AlexTheCat123 on March 26, 2025, 11:53:50 am ---If you're not already doing it this way, maybe try connecting straight to your Lisa's VSYNC, HSYNC, and VID signals instead of hooking the RGBtoHDMI to the Lisa's composite output. That's how I do it and it's incredibly reliable, not to mention sharp.
--- End quote ---
Connecting to the signals requires running cables to the video card yes?
--- End quote ---
No, these signals are also available via connections to the motherboard or CPU board (which is safer than digging around in the CRT area).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version