LisaList2

Advanced search  

News:

2022.06.03 added links to LisaList1 and LisaFAQ to the General Category

Pages: [1]   Go Down

Author Topic: 400k floppy problems. Rom issue?  (Read 1705 times)

Steve100

  • Newbie
  • *
  • Karma: +2/-0
  • Offline Offline
  • Posts: 5
400k floppy problems. Rom issue?
« on: October 09, 2024, 03:52:20 pm »
I’ve been slowly getting round to restoring my 2/5, and I’ve hit a bit of a strange one. I turned my attention to the 400k floppy drive and un-seized it. motor spins up, ejects etc.  the read write head often goes right past where it should and starts clonking but I’m think it’s a rom problem and not a faulty drive. My Lisa still seems to think it has twiggies attached? It does have the Lisa lite card attached. My thinking is the roms are incorrect on the cpu board as a bit of digging looks like they are revision C and not H. Any ideas? I’ve attached photos. Hopefully they won’t be too massive in size to read.
Logged

sigma7

  • Administrator
  • Sr. Member
  • *****
  • Karma: +149/-1
  • Offline Offline
  • Posts: 394
  • Warning: Memory errors found. Verify comments.
Re: 400k floppy problems. Rom issue?
« Reply #1 on: October 09, 2024, 04:42:06 pm »
Quote from: Steve100 on October 09, 2024, 03:52:20 pm
... 400k floppy drive and un-seized it. motor spins up, ejects etc.  the read write head often goes right past where it should and starts clonking but I’m think it’s a rom problem and not a faulty drive.

If this is correct: Lisa I/O Board ROMs, then the I/O Board ROM appears to correctly match your 400k drive.

The 68000 CPU doesn't directly access the floppy hardware, only the 6504 on I/O Board does so. So although the older ROMs on the CPU board incorrectly show upper and lower drives in the startup-from menu, I don't think that alone can cause the FDC to send erroneous commands to the floppy.

Also, whereas the Twiggy head stepper phase lines are controlled by the 6504 FDC (similar to an Apple ][ drive) which can result in weird drive behaviour if the I/O Board is malfunctioning, the 3.5" drives are controlled by a step in or step out signal, and IIRC the drives are smart enough to not go beyond their limit.

Hence, I suspect a problem remains with the drive itself, eg. a photo-interrupter blocked or disconnected so the the drive electronics cannot sense the head carriage position.
Logged
Warning: Memory errors found. ECC non-functional. Verify comments if accuracy is important to you.

Steve100

  • Newbie
  • *
  • Karma: +2/-0
  • Offline Offline
  • Posts: 5
Re: 400k floppy problems. Rom issue?
« Reply #2 on: October 09, 2024, 05:15:49 pm »
Many thanks for your detailed reply and confirmation that the roms are unlikely to be the issue. I have two working io boards and 2 motherboards with the same results, so was a bit confused. I’ll take a closer look at the drive itself. Sadly don’t have a spare drive to compare. Much appreciated
Logged
Pages: [1]   Go Up
« previous next »