General Category > LisaList2
Lisa and TCP/IP - Ethernet or ??
Lisa2:
I have had my Lisa online since 1999. Over the years I have tried all the possibilities to connect. My preferred method is to use MacIP over Localtalk. I have the SCSI to Ethernet adapters ( even the new SCSI wifi clones), but they are not any better or much faster than using the Localtalk port that is built into the Lisa. I use a Gatorbox, but there are many other options available today to setup a MacIP gateway.
Rick
Lisa2:
--- Quote from: bmwcyclist on February 18, 2025, 10:44:07 am ---https://shop.rabbitholecomputing.com/products/zuluscsi-rp2040-pico-slim
--- End quote ---
Don't buy the Zulu SCSI!
Buy a blueSCSI:
https://bluescsi.com/
https://bluescsi.com/docs/WiFi-DaynaPORT
bmwcyclist:
Thanks!
sigma7:
--- Quote from: bmwcyclist on February 18, 2025, 10:38:23 am ---I have purchased a SCSI XLerator, do I need ANOTHER SCSI card or just SCSI to Ethernet/Wifi?
--- End quote ---
You don't need a SCSI expansion card if your XLerator has SCSI installed.
If you were to install a SCSI expansion card as well, you can use only one or the other SCSI port. One uses the XLerator control panel to turn on/off the XLerator SCSI port (if it is off and a SCSI expansion card is installed, then that card's port is used).
Note that SCSI support was introduced in MacWorks Plus 1.0.something and is in MW+II. SCSI isn't supported in LOS, Workshop, Xenix, MacWorks XL as there are (currently) no drivers.
bmwcyclist:
extremely helpful, thank you!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version