General Category > Lisa Troubleshooting and Repair
Will the Lisa return an IO error without the "Lite" Interface Card
friedboard:
Thank you!! It's just a generic multi-meter but I can certainly get a better one.
Trying to figure out where to start, would you happen to have the schematics of the IO board on a lisa 2/10?
stepleton:
They are TIFF files, but you can find them here:
http://www.bitsavers.org/pdf/apple/lisa/hardware/Lisa_2_10_IO_Board/
(In general, bitsavers has all sorts of valuable documentation and is a good place to check if you are looking for anything like this.)
You can also find some reverse-engineered schematics here:
https://lisaem.sunder.net/LisaSchem/Lisa210SysIO1.gif
https://lisaem.sunder.net/LisaSchem/Lisa210SysIO2.gif
https://lisaem.sunder.net/LisaSchem/Lisa210SysIO3.gif
https://lisaem.sunder.net/LisaSchem/Lisa210SysIO4.gif
https://lisaem.sunder.net/LisaSchem/Lisa210SysIO5.gif
which I believe were made by someone or some people on this forum. They are easier to read than the paper scans of the Apple originals. Up until a few years ago, they were the only option the Lisa community had. But being made by a third party, there's a greater chance of encountering errors.
Navigation
[0] Message Index
[*] Previous page
Go to full version