A Lisa Inside An FPGA

[sigma7]

there is no LOS FTP client?

Correct, there is none (for now at least).

LisaTerminal is the only transfer option that comes to mind.

edit: and IIRC, Stepleton captured some LOS print output recently, and massaged it into text and graphics for a modern system.

Aside: How many of you would prefer a post like this be moved to its own topic, or do you not care if subject titles are less specific?

[bmwcyclist]

I have been unsucessful in getting my LISA FPGA to boot into LOS.

I have used a copy that works on my 2/10 "

Any suggestions?

[karmann68]

I have been unsucessful in getting my LISA FPGA to boot into LOS.

I have used a copy that works on my 2/10 as well as the GitHub "LOS Compilation Base.image"

Any suggestions?

What brand/model of SD card are you using? Alex mentioned some don't work

[bmwcyclist]

[/quote]

What brand/model of SD card are you using? Alex mentioned some don't work
[/quote]

Several models all high speed.

Interestingly, I just got it to boot off of LOS 2.0!

[ried]

Tim, have you tried downloading and using the LOS 3.1 disk image that I attached to this post?

Since the pre-existing LOS 3.1 disk images didn't work for me - even those labeled "fresh install" - I went ahead and created a 10MB disk image and installed LOS 3.1 with all of the 7/7 apps. These should work for everyone if the LisaFPGA uses the same Video State ROM on all LisaFPGA builds. Cheers.

[bmwcyclist]

Tim, have you tried downloading and using the LOS 3.1 disk image that I attached to this post?

Since the pre-existing LOS 3.1 disk images didn't work for me - even those labeled "fresh install" - I went ahead and created a 10MB disk image and installed LOS 3.1 with all of the 7/7 apps. These should work for everyone if the LisaFPGA uses the same Video State ROM on all LisaFPGA builds. Cheers.

No, I missed that. Thank you. I'll give it a try tomorrow!

[AlexTheCat123]

I have used a copy that works on my 2/10 "

That's probably why! Either use an LOS image that was made on a 2/5, or install a jumper wire between GPIO0 and 3V3 on the board to trick it into thinking that it's a 2/10.

[bmwcyclist]

I have used a copy that works on my 2/10 "

That's probably why! Either use an LOS image that was made on a 2/5, or install a jumper wire between GPIO0 and 3V3 on the board to trick it into thinking that it's a 2/10.

Thanks! I love this thing, I am learning quite a bit I never knew about LISA and the LOS!

[bmwcyclist]

ried's build works great! Thanks!

Still not getting the LOS Compilation Base.image to work even with the sm fcc180 00ff 0055 00aa PRAM reset.

Going to try the jumper next...

[bmwcyclist]

Compilation image DOES work once 2/10 jumper is installed on the FPGA!