Hi Patrick,

very very very likely that one of the secondary diodes has a shortcut. So before you solder out all the caps, first try to make some measurements instead of a try-and-error-repair :-)

There's only one big dual-diode (looks like a transistor in the metal-housing) which is probably the bad one if you describe that clicking-sound. It's overcurrent shut-down, because that diode has a shortcut. Try to measure with an ohm-meter one of both contacs at the soldering side with the housing of that diode. There must be one good and one with less than 0,5 ohm. Else try all the diodes vertically mounted, they could be bad too

greetings TOM from Bavaria, the center of europe, the marvellous

castles of Koenig Ludwig e.g. Neuschwanstein and last but not least

the original Oktoberfest !

Am 21.03.2007 um 11:13 schrieb Patrick Garber:

Could the "solid state relay" be bad?  Because I hear  

clicking when I hold the power button in.  I read this http:// 

lisafaq.sunder.net/lisafaq-hw-pwr_Lisa_does_not_power_on.html

Thank you

Patrick