I've finally got around to looking at my 400 K floppy. I've pulled out the eject mechanism fully cleaned it and lubricated it.
I plugged it into my FPGA and it doesn't like my floppy.
When I go to format it, it doesn't look like it's seeking correctly. The stepper motor doesn't seem to go all the way to the top of the access window. Am I seeing this wrong?
Quote from: bmwcyclist on Yesterday at 07:17:17 AMit doesn't look like it's seeking correctly. The stepper motor doesn't seem to go all the way
I recently had 400K drive trouble... worked fine for a while then something similar, wouldn't step properly in some places.
Cleaning & relubricating the lead screw fixed it.
Quote from: sigma7 on Yesterday at 03:21:39 PMQuote from: bmwcyclist on Yesterday at 07:17:17 AMit doesn't look like it's seeking correctly. The stepper motor doesn't seem to go all the way
I recently had 400K drive trouble... worked fine for a while then something similar, wouldn't step properly in some places.
Cleaning & relubricating the lead screw fixed it.
Thanks! I put some "super lube" on it but did not clean or run it back and forth by hand.
I'll give that a try.