Re: BLU on a 2/10: RX but no TX?

There have not been any reports of BLU not transmitting, so I expect there is a hardware problem.

You could put your voltmeter between pin 2 of the serial port and ground (eg. the chassis) and see if the voltage fluctuates when you type in the Terminal Test. You may need to set your meter to mV AC to see this, or it may be visible on the 20V DC range. Setting the SCC to the slowest speed possible may help make the voltage change visible. (eg. 9600 baud in the current version of BLU).

Yes, BLU will back up ProFiles attached to a parallel port card.

The I/O board ROM and drive swap are all that is required to switch between 400k and 800k.

The hardware to support LocalTalk is original to every I/O board, so no modifications were required.

>Is there any good reason why BLU should fail to transmit data from
>Port B of a 2/10, even while data reception is fine (or so the
>terminal test screen would indicate)?

>a 400K drive was swapped back in place of the 800k drive,
>along with the corresponding I/O board ROM. I don't know if that's
>relevant, but I suppose there's a chance that the backwards
>reversion to a Lisa was not complete, and modifications to the
>serial port intended to support e.g. LocalTalk are still in place.

>will BLU back up ProFiles attached to a parallel port card?

-- 
-- 
-----
You received this message because you are a member of the LisaList group.
The group FAQ is at http://lowendmac.com/lists/lisa.html
To post to this group, send email to lisalist_at_email.domain.hidden
To leave this group, send email to lisalist+unsubscribe_at_email.domain.hidden
For more options, visit this group at http://groups.google.com/group/lisalist
--- 
You received this message because you are subscribed to the Google Groups "LisaList" group.
To unsubscribe from this group and stop receiving emails from it, send an email to lisalist+unsubscribe_at_googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.