Re: Lisa Disk Drive

From: macmoni <macmoni_at_email.domain.hidden>
Date: Mon, 27 Feb 2006 08:21:48 +0100


that have been the correct two PINs. It should work. I never saw a Lisa, where this kind of "Drive-support" didn't work. Lisa 2 or Mac XL, doesn't matter - it should work.

So the only conclusion is after testing it with a second manipulated drive, that your I/O Board or your motherboard could bee corred or has some broken wires on the board

TOM from Bavaria

Am 26.02.2006 um 20:57 schrieb Jerome Vernet:

> Hi,
> I'm pretty sure that I had cut the right pin. take a look at my photo:
> I put in red what i had removed, and the track cutted under the red
> cross.
> For the ribbon (20 wires), wire 1 is the red (colored, some time) and
> goes to the left on my picture. I count 9 wire, cut this one. I cut
> the last (20). Not working.
> It sould have worked ! It's equal to cut on the ribbon or remove the
> pin or cut track from the pin.
> So, I cut the track that goes to PIN 9 to a resistor -I ve checked
> that with un mutlivolter- then cut the 20th. Same thing...
> perhaps the drive is also dead, so I will retry with another one
> (without killing anything on the drive itself).
> I really need your grateful help, stay tuned !
> Jerome

LisaList is sponsored by <> and...

Shop and save. <>

      Support Low End Mac <>

LisaList info:          <>
  --> AOL users, remove "mailto:"
Send list messages to:  <mailto:lisalist_at_email.domain.hidden>
To unsubscribe, email:  <mailto:lisalist-off_at_email.domain.hidden>
For digest mode, email: <mailto:lisalist-digest_at_email.domain.hidden>
Subscription questions: <mailto:low_end_mac_at_email.domain.hidden>
Archive: <>

iPod Accessories for Less
at 1-800-iPOD.COM
Fast Delivery, Low Price, Good Deal
Received on 2006-02-26 23:22:22

This archive was generated by hypermail 2.4.0 : 2020-01-13 12:15:20 EST