Re: Sleeping Lisa

From: Jim Carroll <jcarroll_at_email.domain.hidden>
Date: Mon, 6 Nov 2000 13:48:44 -0800


Thank You very much for your reply. Upon first read of your response I must say it is a bit over my head technically but I will take your message home and while working with the Lisa hope it will come clear. I will also check the motherboard as I didn't give that a very close look for damage. I did have 1 open connection in the I/O board but successfully soldered a wire to close it. I'll let you know what I find out...

Thanks again,

  Jim

-----Original Message-----
From: jlewczyk_at_email.domain.hidden [mailto:jlewczyk_at_email.domain.hidden] Sent: Monday, November 06, 2000 1:33 PM
To: lisalist_at_email.domain.hidden
Subject: Re: Sleeping Lisa

The power supply has a soft-on feature. It supplies a standby voltage to the
IO board, which powers a COPS microcontroller chip. This chip recognizes the

shorting of the power switch and asserts a "power up" signal to the power supply, which then brings up all the voltages the Lisa requires to run.

For a Lisa 1 or Lisa 2 (not a Mac/XL, whose IO board is different so I can't

speak for it)...

You can test the power supply somewhat as follows... To simulate the shorting
of the power switch, short IO board pin-119 to ground (IO Pin-113). If this

works, the COPS is OK and the connection between the power switch and the IO

board is bad.

The signal to the power supply to turn it on is asserted with +5V at pin X
(a grey wire that goes to from the supply to the front interlock switch).
The
+5V standby voltage from the power supply is on the supply's pin 20, which is
the white w/yellow wire.

On the IO board, the power supply "turn on" signal is produced by U7F pin 12
(a

74x07) and is also accessable on C33 + (47mf), near the right edge of the io

board as viewed from the back near the middle. It comes off the IO board at

pin 120, which you can't get at because its on the solder side of the IO board.

Hope this helps. Let me know if you need more info.

If you've had leakage of the batteries (like mine did), then some traces on the
motherboard may have been damaged. On mine, it caused open connections between
the sockets and the motherboard traces at the points where the socket pins were
inserted into the motherboard. I repaired each by soldering wires under the

motherboard between locations I found open.

----------original message -----------------------------------------------
My Lisa died a few years back and I recently attempted to revive her. I thought I had a bad power supply but just acquired a new one but I still get no power. I thought I read somewhere if your Lisa is not getting power then it is either the power supply or I/O board. Can anyone confirm this. I did remove the leaking batteries on my I/O board and some minor corrosion was present but I checked all the circuit pathways with a meter and all are ok. I also checked the micro switch in front and it seems ok. I don't know how to test the power button, could this be my problem. Any advice on what to check/try next would be appreciated.

Thanks,

  Jim



This message was sent via http://webmail.his.com. http://www.his.com/

MacResQ Specials: LaCie SCSI CDR From $99! PowerBook 3400/200 Only $879! Norton AntiVirus 6 Only $19! We Stock PARTS! <http://www.macresq.com>

Shop buy.com and save. <http://click.linksynergy.com/fs-bin/ stat?id=O7sajHhUCjc&offerid=13541.10000001&type=1&subid=0>

Host your mailing list for free at Maclaunch http://www.maclaunch.com/forms/list.shtml - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - This message is sent to you because you are subscribed to LisaList.  Send list messages to <lisalist_at_email.domain.hidden>  To unsubscribe, send email to: <lisalist-off_at_email.domain.hidden>  To switch to digest mode, send email to <lisalist-digest_at_email.domain.hidden>  Email subscription questions to <listmom_at_email.domain.hidden>  List archive at <http://mail.maclaunch.com/lists/>

MacResQ Specials: LaCie SCSI CDR From $99! PowerBook 3400/200 Only $879! Norton AntiVirus 6 Only $19! We Stock PARTS! <http://www.macresq.com>

Shop buy.com and save. <http://click.linksynergy.com/fs-bin/ stat?id=O7sajHhUCjc&offerid=13541.10000001&type=1&subid=0>

Host your mailing list for free at Maclaunch http://www.maclaunch.com/forms/list.shtml - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - This message is sent to you because you are subscribed to LisaList.  Send list messages to <lisalist_at_email.domain.hidden>  To unsubscribe, send email to: <lisalist-off_at_email.domain.hidden>  To switch to digest mode, send email to <lisalist-digest_at_email.domain.hidden>  Email subscription questions to <listmom_at_email.domain.hidden>  List archive at <http://mail.maclaunch.com/lists/> Received on 2000-11-06 13:53:25

This archive was generated by hypermail 2.4.0 : 2020-01-13 12:15:17 EST